ix Industrial is a new standardized, miniaturized Ethernet compatible interface in compliance with IEC/PAS 61076-3-124. ix Industrial™ features a 75% reduced size compared to RJ45 modular connectors. The receptacles allow for a parallel 10mm pitch mounting for daisy-chaining in compact units contributing to size reduction of end use products. Two coding options are available: A and B.

A small current fuse that can interrupt DC 450V.
The new “DC fast-acting microfuses KB series” is compact and user-friendly by combining the alloy technologies and long experience of safety parts manufacturing that has been cultivated for over 100 years.
KB satisfies the needs to achieve both protection performance and design cost.

It can accept high current, 75A DC, and open a circuit quickly by receiving signal-current.
It can open a circuit quickly, within 60 sec. at room temperature by low signal current, below 1.5A.
Resistor portion is connected to fuse portion electrically and it can cut off the both portions simultaneously.
It can be installed by fastening screw.

Non-resettable thermal cutoff.
Extremely simple construction ensures reliability, and hermetically sealed thermal element reduces deterioration with age.
Superior thermal sensitivity.
Insulating container.
NC Series: suitable for reflow soldering.

High temperature tolerance.
Widely temperature range of application.
Inner device is formed by glass encapsulation which has high reliability so when the coffee maker heated without water or breakdown, it will not damage the NTC sensor.
The planeness of NTC SENSOR can be controlled well so that it can improve the measurement accuracy.

Breakdown voltage (100V/s): 2,400-4,800V
Surge discharge current: 3,000A
Ignition voltage (1kV/µs): ≤ 2,500V
For HiPot test ≥1,500V AC or ≥2,000V AC
Size design: 9,0 *5,5 *7,0mm or 8,8 *6,2 *8,7mm
High current endling capability 3kA @8/20 µs

THERMAL LINKS
- E2 Series
- ETR Series
Micro fuse:
- KB series
Current fuse with resistor:
- FV

High performance thermal cutoff which combine a cement resistor with a fusible alloy type tco.
Overheat protect function.
Superior characteristics against inrush current.
Extremely robust electrical insulation and voltage withstanding properties after it functioned.

High performance tco which combine two coil-winding resistors with a fusible alloy type thermal cutoff.
It reduces the mounting space and decrease the number of components.
It uses a coil-winding for greater ability to withstand inrush current the marking printed on the topside make easier to confirm the products.